Head Milled or thinner Gasket?
#1
Thread Starter
Join Date: May 2002
Location: Fontana, ca, USA
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
Head Milled or thinner Gasket?
I was wondering is it better to get your head milled or buy a thinner gasket. I have a D16z6 and I am looking to up the compression for more power. So has anyone had any luck with either method? And Where can I buy a thinner gasket or is there a stock gasket I can use that is thinner than mine?
#2
Honda-Tech Member
Join Date: Jul 2001
Location: Dirty Jerzy, USA
Posts: 1,688
Likes: 0
Received 0 Likes
on
0 Posts
Re: Head Milled or thinner Gasket? (SoCaLiStReEtRaCeR)
once it's milled there is no turning back,in case you ever wnated to turbo.make sure the shop is reputable.i woudn't do more than .020.good luck
Thread
Thread Starter
Forum
Replies
Last Post