Water/Meth Fail Safe Transducer Hook Up need help :)
#1
Honda-Tech Member
Thread Starter
Water/Meth Fail Safe Transducer Hook Up need help :)
I have the below pictured Transducer with Devils Own/Controller Water/Meth inj kit. It is a 3 wire setup. I have the Transducer T'd inline with the control solenoid after. So pump-transducer-control solenoid.
From my understanding Blk wire is grounded. Grounded to Thermostat. Red wire is ran to the ECU and Blue is not used. I have a Hondata s300v2 does the Red wire go to one of the analog pigtails that the v2 has? I am looking where to put this 1 wire? Also I am curious how do you set this up for fail safe protection is there a certain program such as nitrous to control this in order to back down boost etc? I am not an electrical wiz. But 1 wire short from completion Tuner can handle the rest...
Thanks for the help.
From my understanding Blk wire is grounded. Grounded to Thermostat. Red wire is ran to the ECU and Blue is not used. I have a Hondata s300v2 does the Red wire go to one of the analog pigtails that the v2 has? I am looking where to put this 1 wire? Also I am curious how do you set this up for fail safe protection is there a certain program such as nitrous to control this in order to back down boost etc? I am not an electrical wiz. But 1 wire short from completion Tuner can handle the rest...
Thanks for the help.
Thread
Thread Starter
Forum
Replies
Last Post
ESP.net
Engine Management and Tuning
10
04-13-2015 03:41 PM
T25 civic
Forced Induction
2
10-06-2002 02:11 PM