buckfittyone

since pin 1 on cn2 is ground can i just take the brown wire from my nokia cable and route it to another ground source in the ecu?or am i screwed

ILLICON3000

blame bush

093turbo16

iTrader: (2)

You screwed up top and bottom? you can run it to where the trace goes. Follow it and solder it there, might be a big pain in the ***.

buckfittyone

yeah good thing you edited your previouse response illicon3000 ,that would have made you look real smart i asked a legit question,if you dont have a relevent answer that actually pertains to what im askin please dont even waste my thread space dude

093turbo16

iTrader: (2)

any comments on what I said? LoL. I had to do this before actually but only on some ecu a kid screwed up. Pulled the traces out when he tried to pull a socket out. That was a nightmare....

ILLICON3000

You want a relevant answer?

Quit acting like the keyboard mechanic that you aren't and take it to the shop!

buckfittyone

im trying to follow the trace but pin 1 doesnt seem to have a visible trace i can see where pin 2 and 3 go but 1 4 and 5 arent even visible

buckfittyone

thanks 93turbo16 i got it figured out,im glad it was pin1 that i messed up,if it would have been one of the others this whole deal would be much much harder

buckfittyone

ok new rule, even if you think your post is relevent,still dont post in my thread.its obvious you have nothing constructive to say so please go find somewhere else to go be a dick.any further responses will be ignored so you can just go to sleep now,ive entertained you long enough