diviznrider

no oil on dipstick after driving home from tune on my turbo ls vtec. figured it was low and did an oil change. about 4 quarts or more was drained and i put in about 4.2 quarts back in but it still shows nothing on my dipstick. do all my oil lines for turbo and lsvtec factor into that much more oil i need to pour in? i dont want to overfill it.

Slacker93eg

Stupid question, but, is the dipstick going all the way into the tube?

diviznrider

yea of course which confuses me

Dc4LsTeG

iTrader: (7)

Are you sure the tube is all the way in the block?

civicjunkie17

iTrader: (1)

When are you checking the oil? If you check the oil right after the car is running or right after you poured the oil in the car doesn't allow the oil to drain all the way to the pan. Check it in a few hours after not running the car?

guess_who

Do you have an aftermarket oil pan? could be more than 4qts?

Turbo-LS

iTrader: (4)

Sounds like dip stick tube isn't all he way into the block or larger pan ? D series dipstick?

diviznrider

checked twice with 2 different dipsticks it is a b series dipstick. the motor was assembled by someone else, maybe the dip stick tube needs to be fixed. is it possible to fix it without pulling my turbo setup (manifold, downpipe, wastegate) ?

Dc4LsTeG

iTrader: (7)

Maybe depends on your manifold and everything. Maybe try tapping the top of the tube to make sure its all the way in the block

Turbo-LS

iTrader: (4)

Just look down at the tube. If the little ring around it isn't fully seated to the block then you know it's not all the way in. I couldn't get mine to go all the way in on my c
Block for whatever reason but I know that the low oil mark on my dip stick is actually reading full

MRGRIM

iTrader: (1)

i own 6 motors and they are all the same
tube DOES NOT SIT ALL THE WAY DOWN
3 JDm 1 USDM 2 AUDM

OP do an oil change and mesure the amount you put in in spec with your engine

Nailclipper

i have a turbo Ls/V and i put in damn near 4-3/4 quarts to bring it up to full. if you know for a fact that the dipstick tube is in correctly and you do not have an over size pan , that should do it. depending how long your oil line is and the oil feed for the head, they COULD hold up to 1/4 of a quart.

v8killaz

is the car running or is the car off when you check it.
i know to some it may be a stupid question but my freind who thinks he knows all about cars had a turbo teggy and would always tell me the car was burning oil and ate through 4 qts again. one time when he called me complaining i just jokingly said the car is off right. and he was like no the car is on.
i was like wtf is this real life

Jeffaj20

Ok, stupid question... lol

But are you checking to see if the dipstick is wet? Cause i've done that before wondering why there wasn't any oil and it was just really clear.

93h2beg

i had a customer car come in, he said a similar thing. that even after a oil change nothing on his dip... i pulled it out and sure enough nothing on it, also the dipstick was broken off and was short about an inch....

v8killaz

wonder there the other piece was
lol