head milling hlp pls
08-10-2010, 12:56 AM
#1
Honda-Tech Member
Thread Starter
head milling hlp pls
for anyone taht has experience with the p07 piston
heres my plan :
d15z1 block /w stock pistons/rods (p07)
d16y8 head
about 6 lbs boost
this is my question how much can i mill the head?
the reason for this is its about 8:1 compression or so before the milling
* for those that dont know the p07 is heavily dished so i shud be able to mill it quite a bit without valve to piston contact
according to the calculator .1 inch mill would give me teh compression that i am looking for
heres my plan :
d15z1 block /w stock pistons/rods (p07)
d16y8 head
about 6 lbs boost
this is my question how much can i mill the head?
the reason for this is its about 8:1 compression or so before the milling
* for those that dont know the p07 is heavily dished so i shud be able to mill it quite a bit without valve to piston contact
according to the calculator .1 inch mill would give me teh compression that i am looking for
Last edited by 2kdrift; 08-10-2010 at 02:11 AM.
Thread
Thread Starter
Forum
Replies
Last Post
asubennett
All Motor / Naturally Aspirated
6
06-10-2004 04:10 PM
Mentat Ghola
All Motor / Naturally Aspirated
14
05-11-2004 02:35 PM
