def90man

Hi all, quick question

I just recently built my bottom end a d16a for a greddy turbo kit, going to begin at about 7-12 pounds

D16A
Eagle h-beam rods
JE pistons 9.4:1
ARP studs
Stock d16y8 head

I blew my current d15b7 i was wondering if i could swap in the d16 with out the turbo at the moment if i use my p06 and intake manifold / injectors from the d15b7?

Later on change to the p28 and 440 DSM when i install turbo/Tune... this is my daily unfortunately and it blew before i could finish my swap/turbo

Freemananana

iTrader: (3)

Yes. You can swap the block, keep the same intake/injectors/etc and run on the stock ECU.

def90man

Thank you!

I was mainly worried of any changes to air/fuel ratio etc