Car Idling too way too high or normal. Innovate Wideband and S300
#1
Car Idling too way too high or normal. Innovate Wideband and S300
B17 w/ 11.1 compression, B18 Gs-R Head, 1st gen skunk 2 intake mani with IHE.. My car was running perfectly fine until I installed the wideband o2
wired it into the D10 ELD input with Hondata s300 in P28. Also removed r136 + r138 resistors for a more accurate reading..
Running Innovate MTX-L wideband
Conversion Table: 0v - 7.35
5v - 22.39 w/ -.01 voltage difference and o2 heater disabled
currently running it in open loop because I am not fully tuned... when starting it up, car acts normal, after it warms up and idles it stays at a normal speed (in the 800s rpm). When I start driving it, it'll hold at 1500 rpm at stop signs. then when i stop to idle again it just does not want to idle it'll hold at 1500. sometimes it idles normal tho ... it has a mind of its own now ...... I NEED HELP !!!!!!!
wired it into the D10 ELD input with Hondata s300 in P28. Also removed r136 + r138 resistors for a more accurate reading..
Running Innovate MTX-L wideband
Conversion Table: 0v - 7.35
5v - 22.39 w/ -.01 voltage difference and o2 heater disabled
currently running it in open loop because I am not fully tuned... when starting it up, car acts normal, after it warms up and idles it stays at a normal speed (in the 800s rpm). When I start driving it, it'll hold at 1500 rpm at stop signs. then when i stop to idle again it just does not want to idle it'll hold at 1500. sometimes it idles normal tho ... it has a mind of its own now ...... I NEED HELP !!!!!!!
Last edited by Team_Coast978; 10-04-2013 at 11:45 AM.
Thread
Thread Starter
Forum
Replies
Last Post