b00stedOne

iTrader: (1)

I have a set of 24.5x8x13" slicks that I want to run on my 96 integra. What are most people doing to run 13" rims without having an issue with the break caliper rubbing?
I was thinking about just using civic front knuckles. If I do this, will everything bolt right up?

thanks.

96 GSR-T

The Bogarts I ran had a 1/2" spacer already mounted to them, I had full lock to lock and no rubbing issues with the MH 24.5x8.7x13's

narfdanarf

I never had an issue with the caliper with my 13" lenso's, I did however have to buy 1/2" spacers to keep the 24.5x9x13 MT off the knuckle.

b00stedOne

iTrader: (1)

I already have a set of these rims
http://www.aeroracewheels.com/wheel_...ne_series.html

I ran them on my old civic with no problem, but I dont think they will clear the integra breaks.

dpetro1

what width and back spacing? they should work

b00stedOne

iTrader: (1)

they are 7.5" wide. im not sure about the back spacing. I dont know much about that stuff. They did stick out past my fenders. here is a pic of them on my old civic.

jdm inc

iTrader: (11)

the lenso fit on there without and modifications.
http://www.exospeed.com/category.php?id=427

ExospeedAMcrx

Alot of Drag Wheels fit for Integra and will for for Civics as well. You dont need to switch your Integra knuckle to a Civic to make these 13" drag wheels work.

Martian

I used to own a set of those. They are arrow midget cart wheels. 13x7 with a 4" backspace. Good cheap steal wheel, and they clear the caliper because of the huge backspacing.