szczerbanator

So I had the 5901 Viper installed, as well as other components. One of them being the DEI 508d Proximity. They told me that they cant wire up BOTH proximities, warn away and full alarm.

WTF.

So now if someone walks up to my car, the full siren goes off.

How can I get this wired correctly?

fcm

((((((((((((Optional sensor port - 4-pin connector))))))))))))))

There is a shock sensor built onboard the main unit. This connector is an optional
sensor port to add sensors to the security system. Optional sensors that may be
used are: 508D Doubleguard Proximity Field Disturbance, 509U Ultrasonic
Sensor, 506T Glass Break Sensor, and 507M Digital Tilt Sensor.
This input can also be used for a second 504D Doubleguard Shock Sensor, or
for additional pin and magnetic switches.
Page 28 of install guide. 94

szczerbanator

^ your a baller man. You have it down to the page #!

szczerbanator

Oh wait i think my backup battery is in that port

baller status

Backup batteries don't use a port. They have a single trigger output.

They just need to adjust the sensitivity. The signal for both warn and full trigger is on the same wire.

szczerbanator

Thanks for the input, im just going to go back when a different installer is there w/ more knowledge

fcm

Ditto, the BB should not be on that port, BB trigger should be wired to hood pin switch input.

The extra sensor input has both the warn a way and full alarming trigger input, along with power and ground. 94

szczerbanator

k Thanks guys