zc sohc block with pm7 pistons and a y8 head, ????????
hey I need to know quick I putting this set up, on a zc block (sohc) with pm7 pistons (89 integra), on a y8 head. dose any one know if it will clear???? do I have to advan or retard the timing at all???? is any one running this set up.? pls help building block tommorrow, (spun a rod bearing on old block) pls bump if you check it out, thanks
haha wow that was the exact same setup i was running in my ef a while back before i realised how much i love bseries. But regarless slap it together torque everything right and roll out, its a pretty quick motor i beat gsr's and si's.
[B]SOHC[/B] boost retired
[B]DOHC[/B] boost <FONT COLOR="red">JDM</FONT> b18c
t4 goodness [img]http://images.honda-tech.com/set1/smile/emthup.gif[/img]
I <FONT COLOR="red"> [B]<3[/B]</FONT> IHN
thanks bro there was not prob with the clearance ?
this is old but just to clarify---
no. there is no issue with clearance- you can even run a hefty cam with p29 piston/ y8 head and have no issues (as long as the head has not been milled extensively (more than .010) and the block hasn't been decked more than .010
'09 Mercedes-Benz C63 AMG / '14 Audi Q5 3.0 S-Line / '99.5 Pathfinder SE / END OF AN ERA / 5'16", 154.2 kgs / RON PAUL
Honda and the Honda marquee are registered trademarks of the American Honda Motor Company, Inc. Neither American Honda Motor Company nor its subsidiaries or affiliates shall bear any responsibility for Honda-Tech.com content, comments, or advertising. Honda-Tech.com is not affiliated with American Honda Motor Company in any way. American Honda Motor Company does not sponsor, support, or endorse Honda-Tech.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.