Opinions on RS Machines 12.5 cr pistons
#1
Honda-Tech Member
Thread Starter
iTrader: (2)
Join Date: Jun 2007
Location: pocatello, idaho, u.s.a.
Posts: 3,648
Likes: 0
Received 0 Likes
on
0 Posts
Opinions on RS Machines 12.5 cr pistons
I was wondering if anyone has had any experience (good/bad) with these pistons? They are super cheap, but I am worried about "getting what I pay for". LMK what you guiys think.
#4
Honda-Tech Member
iTrader: (1)
Join Date: Jun 2008
Location: Earth
Posts: 1,537
Likes: 0
Received 0 Likes
on
0 Posts
Re: Opinions on RS Machines 12.5 cr pistons
OP, I've used them on several rebuilds, none have had problems. Have the block overbored if necessary and make sure you give the machinist/builder the pistons and rings before any machine work begins.
#6
Honda-Tech Member
Join Date: Sep 2001
Location: socal, ca, US
Posts: 6,067
Likes: 0
Received 0 Likes
on
0 Posts
Re: Opinions on RS Machines 12.5 cr pistons
I swear by RS ITR cast pistons...i think my dyno sheet speaks for itself ;-)
my B20V setup ran the very first set of their RS ITR cast pistons and made some decent power and torque on pump gas...daily drove the motor for like 4-5 years with no problems on socal streets
my B20V setup ran the very first set of their RS ITR cast pistons and made some decent power and torque on pump gas...daily drove the motor for like 4-5 years with no problems on socal streets
Thread
Thread Starter
Forum
Replies
Last Post
99blackvti
All Motor / Naturally Aspirated
4
09-07-2005 01:46 PM