B18b swap done, FITV coolant hose problem, help!
#1
Honda-Tech Member
Thread Starter
Join Date: Dec 2005
Location: Montreal,Qc
Posts: 488
Likes: 0
Received 0 Likes
on
0 Posts
B18b swap done, FITV coolant hose problem, help!
Hi, I swapped a b18b in my 92 teg, I used the b18a1 intake manifold which has the FITV under the throttle body. On obd1 b18a and b18b there is supposed to be a coolant hose runing from the thermostat housing to the FITV inlet (or outlet?), then another hose from the outlet (or inlet?) to the intake manifold.
My problem is that I have no place on the thermostat to run a hose from there to the FITV since I have a 1997 b18b obd2 thermostat housing. I have the hose that goes into the intake manifold though.
I guess if I try to start it with coolant the coolant will leak out the fitv. Can I block it or loop it somewhere without damaging anything or creating unwanted pressure? I don't care about having a bad idle on cold startup. Car needs to be street tuned tomorrow!!!
thanks!!
My problem is that I have no place on the thermostat to run a hose from there to the FITV since I have a 1997 b18b obd2 thermostat housing. I have the hose that goes into the intake manifold though.
I guess if I try to start it with coolant the coolant will leak out the fitv. Can I block it or loop it somewhere without damaging anything or creating unwanted pressure? I don't care about having a bad idle on cold startup. Car needs to be street tuned tomorrow!!!
thanks!!
#2
Honda-Tech Member
Thread Starter
Join Date: Dec 2005
Location: Montreal,Qc
Posts: 488
Likes: 0
Received 0 Likes
on
0 Posts
Re: B18b swap done, FITV coolant hose problem, help!
please guys its the only thing I need to work out before getting street tuned tonight!!!
I need to know if I can plug the FITV where the hose is suppose to connect to the thermostat housing, while still having the other end of the fitv connected to the intake manifold and not cause any damage.
thanks!!!
I need to know if I can plug the FITV where the hose is suppose to connect to the thermostat housing, while still having the other end of the fitv connected to the intake manifold and not cause any damage.
thanks!!!
#3
Honda-Tech Member
Join Date: Nov 2008
Location: Rising Sun, Maryland, USA
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
Re: B18b swap done, FITV coolant hose problem, help!
i would get a tee with the same size hose that you know is running coolant and run that into the FITV...did you use the b18B TB or the B18A TB?
#5
Honda-Tech Member
Join Date: Nov 2008
Location: Rising Sun, Maryland, USA
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
Re: B18b swap done, FITV coolant hose problem, help!
i think i am over my head on this one sorry i have just fooled around with OBD1 TB i don't know much about FITV to be honest with you...
Thread
Thread Starter
Forum
Replies
Last Post
Bontke
Acura Integra
4
02-12-2003 04:13 PM