Please HELP (YES I SEARCHED) swapping a k24a4 into a ep3
#1
Honda-Tech Member
Thread Starter
Join Date: Mar 2004
Location: cleveland, ohio
Posts: 3,213
Likes: 0
Received 0 Likes
on
0 Posts
Please HELP (YES I SEARCHED) swapping a k24a4 into a ep3
im new to the whole ep3 world not really sure what will need to be done to put a k24a4 into a ep3 i searched and couldnt really find any info on swaps besides the k20a ............ any help or links will be greatly appreciated
#7
Honda-Tech Member
Thread Starter
Join Date: Mar 2004
Location: cleveland, ohio
Posts: 3,213
Likes: 0
Received 0 Likes
on
0 Posts
i just plan on swapping just the k24a4 into the car i have searched high and low i spent a couple hours last night going threw thread but couldnt find out enough info
Trending Topics
#8
Honda-Tech Member
Join Date: Nov 2006
Location: houston, tx, usa
Posts: 138
Likes: 0
Received 0 Likes
on
0 Posts
Re: (eghatch4sale)
https://honda-tech.com/zerothread?id=1918510
try searching archived content, there were more results than just this one
try searching archived content, there were more results than just this one
#9
Honda-Tech Member
Thread Starter
Join Date: Mar 2004
Location: cleveland, ohio
Posts: 3,213
Likes: 0
Received 0 Likes
on
0 Posts
doesnt have the info i need ...................
i need to know what i will need from the k24a4 and what will i need from the k20a3 i need to know what mounts im going to need ....... i need to know if i can use the k20a3 harness ....... any rewiring needed if the throttle cable is going to work or if im going to need one fron a different car ......... etc .................
i need to know what i will need from the k24a4 and what will i need from the k20a3 i need to know what mounts im going to need ....... i need to know if i can use the k20a3 harness ....... any rewiring needed if the throttle cable is going to work or if im going to need one fron a different car ......... etc .................
#10
Honda-Tech Member
Join Date: Nov 2006
Location: houston, tx, usa
Posts: 138
Likes: 0
Received 0 Likes
on
0 Posts
#11
Re: (bryce-o)
You will need the CRV passenger side motor mount. You can use the rest of the stock ep3 motor mounts. The engine will sit about 19mm higher, you will have to use the k20a3 intake manifold and header unless you already have aftermarket.
Also, if you have KPro you can use your stock ep3 wiring harness then.
This is all from my k24a2 swap, they're the same block with a different head, so it should all be the same.
Any other specific questions? I will try to help or I probably know someone who knows the answer if I don't know it myself.
Also, if you have KPro you can use your stock ep3 wiring harness then.
This is all from my k24a2 swap, they're the same block with a different head, so it should all be the same.
Any other specific questions? I will try to help or I probably know someone who knows the answer if I don't know it myself.
Thread
Thread Starter
Forum
Replies
Last Post
STEALTHMODECOUPE
Honda Civic / Del Sol (1992 - 2000)
5
07-22-2003 06:43 PM