Will JDM ITR axle back bolt on to USDM ITR midpipe?
My girl friend bent her Stock ITR exhaust tip while parking her ITR
well.. here i have found a JDM ITR axle back (2 1/2)
will it bolt on to USDM mid Pipe (2 1/4)??
will i need a different gasket since the JDM one's is bigger?
if i reuse or go HONDA and buy a stock gasket will it leak??
FS: 00' Auto tran mint mint, 03 EP3 SIR CDN cluster(KM/H)
00' ITR engine/tran mounts
Re: Will JDM ITR axle back bolt on to USDM ITR midpipe? (cmdr430)
edit: YES it is a direct bold on
yah my friend had a jdm one like the one you're talkin about that had the tab on the end of the pipe that holds the tip.
at first we thought it was for a 4 door but we went to password jdm and compared to another two door and 4 door axleback and it was definitely for a 2 door.
this led us to believe that the exhausts were different for the 96 spec itr and the 98 spec itr..as the jdm one we had "stuck out a tad more" than the usdm one my other friend had..on a 98-01 rear bumper. we believed the one with the "tab" is a 96 spec.
many itr owners accused him of having a cat that was too long, and all sorts of other things..even though he had a thread with pics and everything comparing the two. but we knew better.
the good news is that the jdm one and the usdm one are actually the same diameter as we measured everything. the bad news is that if you think the jdm one is bigger than the usdm one, you are incorrect.
Modified by ipodhustle at 8:27 AM 3/18/2008
__________________ FUNNIEST **** YOU WILL EVER READ!!!:
Honda and the Honda marquee are registered trademarks of the American Honda Motor Company, Inc. Neither American Honda Motor Company nor its subsidiaries or affiliates shall bear any responsibility for Honda-Tech.com content, comments, or advertising. Honda-Tech.com is not affiliated with American Honda Motor Company in any way. American Honda Motor Company does not sponsor, support, or endorse Honda-Tech.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.