um ok, cant pull ECU codes!
#1
Honda-Tech Member
Thread Starter
Join Date: Mar 2004
Location: Somewhere, NJ
Posts: 427
Likes: 0
Received 0 Likes
on
0 Posts
um ok, cant pull ECU codes!
Ok I just got my JDM swap in, and tried to pull the ECU codes. THe CEL is still on when I start it, and I tried 2 different kinds of jumpers to pull the codes. Paperclip and another one my friend made that worked for his integra fine. But when I turn the car to the ON position nothing comes up. The Brake, Oil, and CEL stay on.(Ebrake up) Just changed the oil and its filled properly, adn the CEL does nto blink at all. Anyone know whats up. Im goin to try to get the codes again today when its running, but Id rather pull them while the car is off just in case somethign isnt hooked up right.
#3
Honda-Tech Member
Join Date: Aug 2002
Location: Somewhere in, CT, USA
Posts: 3,910
Likes: 0
Received 0 Likes
on
0 Posts
Re: um ok, cant pull ECU codes! (JiggyKooAndy)
i had that same problem w/ my hondata setup...i traced to problem down to a pin in the ecu that wasn't fully soldered.
#4
Honda-Tech Member
Thread Starter
Join Date: Mar 2004
Location: Somewhere, NJ
Posts: 427
Likes: 0
Received 0 Likes
on
0 Posts
tried to trace teh wire, it all looks ok and I tried again today, nothing. Even disconnected the battery. The ABS light is on though, is there any fuse I can pull so that the ECU does not register the ABS and so the ABS light does not go on anymore. Hopefully thats my only code im getting. The engine seems to be running fine other then that.
Thread
Thread Starter
Forum
Replies
Last Post
mr_munro
Engine Management and Tuning
8
03-25-2012 04:41 PM
drumminforev
Honda Civic / Del Sol (1992 - 2000)
19
10-06-2006 12:12 AM