Do you have a Lowes home improvement store where you are? It's similar to a Home Depot, but a little newer.
The Lowes near me have a very large selection of metric bolts/nuts. Much more than Home Depot which has like 10 total. I remember going to Lowes for many replacement Honda bolts that I lost during my work.
i don't see a reason why it would back out without the lock nut. the onlything i could think off is that it would be a stiffer conection with the lock nut. why don't you replace the whole thing. you could buy those at any hardware store. or if not try contacting a machine shop,hot rod shop, or a hardware store they might be able to help you locate the nut
Anyway, as far as the question goes... I have Puerto Rican midget named Rico under my hood that I have equipped with a spray bottle of gasoline. When I enter boost, he sprays extra gas in and retards the timing at the distributor for me... or he does if he knows what's good for him.
That's right. As long as you have them set correctly and ensure that the ends apply no preload on the swaybar when the car is on a flat surface the setup will be good.
Once you have them installed, you'll notice that the top half and the bottom half will be "loose" but they will not unscrew more than 1/4 turn from each other and the two halves will never disconnect because the two mounting bolts hold them in place.
Honda and the Honda marquee are registered trademarks of the American Honda Motor Company, Inc. Neither American Honda Motor Company nor its subsidiaries or affiliates shall bear any responsibility for Honda-Tech.com content, comments, or advertising. Honda-Tech.com is not affiliated with American Honda Motor Company in any way. American Honda Motor Company does not sponsor, support, or endorse Honda-Tech.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.