Fabricating Seat Brackets
10-07-2007, 06:12 PM
#1
Thread Starter
Join Date: Oct 2007
Location: orangevale, ca, usa
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
Fabricating Seat Brackets
I have a pair of Yonaka bucket seats im trying to install in my 92 Teg LS but the rails are completely different (wrong length and placement on seat) so i need to fabricate new brackets. Any suggestions as how to go about this?
10-20-2007, 02:50 PM
#3
わたしは。。。
iTrader: (1)
Join Date: Feb 2004
Location: Sacramento
Posts: 8,136
Likes: 0
Received 0 Likes
on
0 Posts
Re: Fabricating Seat Brackets (caliBMXer)
Have you tried the memoryfab 2 piece seat mounts?
They have plenty of play since they are 2 piece so that you can adjust them to fit your car.
They have plenty of play since they are 2 piece so that you can adjust them to fit your car.
10-22-2007, 02:55 PM
#6
Thread Starter
Join Date: Oct 2007
Location: orangevale, ca, usa
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
Re: Fabricating Seat Brackets (caliBMXer)
Thanks but theyre a little expensive. Im thinking of using angle iron horizontally across from front left to front right and same in back but the back two mounts are offset.
Trending Topics
10-23-2007, 01:28 PM
#8
Junior Member
Join Date: Jun 2005
Location: Charlotte, NC, USA
Posts: 178
Likes: 0
Received 0 Likes
on
0 Posts
I made my own seat brackets for my RSX seats in my Integra. I just removed the factory brackets, fabbed up new ones and welded them to the seat rails. As long as you dont mind cutting the existing feet off, and u can bend up some metal, should be no prob.
Thread
Thread Starter
Forum
Replies
Last Post
ottocrossteg
Road Racing / Autocross & Time Attack
18
09-08-2005 06:55 AM
