Dust boots for Koni/GC
#1
Honda-Tech Member
Thread Starter
Join Date: Jun 2003
Location: Qormi, Malta, Malta
Posts: 97
Likes: 0
Received 0 Likes
on
0 Posts
Dust boots for Koni/GC
Hi guys,
I need your opinion here..
I have just installed a new Ground Control & Koni setup on my GSR, while removed the stock springs and Ohlins dampers.
Since Ohlins are a little wider (in diameter) than stock dampers the dust boots were also wider and these could not fit on my new setup.. so I installed the Konis without dust boots.
On Ground Control instructions it says to cut the stock dust boot at 1 1/2 inches of height.
Do you think it is very important to find a set of stock boots?? since cutting them to 1 1/2 inches looks very few and I don't think it makes much difference.
I need your opinion here..
I have just installed a new Ground Control & Koni setup on my GSR, while removed the stock springs and Ohlins dampers.
Since Ohlins are a little wider (in diameter) than stock dampers the dust boots were also wider and these could not fit on my new setup.. so I installed the Konis without dust boots.
On Ground Control instructions it says to cut the stock dust boot at 1 1/2 inches of height.
Do you think it is very important to find a set of stock boots?? since cutting them to 1 1/2 inches looks very few and I don't think it makes much difference.
Thread
Thread Starter
Forum
Replies
Last Post
ONECLEAN91
Honda Civic / Del Sol (1992 - 2000)
12
04-29-2011 06:12 PM