TA Performance

i need your guys help on what this problem may be...
when i accelerate the car vibrates really bad like my tires are not balanced. I got new axles, a used 5 lug conversion, and just replaced new tires and balanced it to see if the tires were the issue. However it still vibrates under acceleration and i tried to shake the wheel left to right to see if the wheel bearing is bad but it doesnt budge.. Really need your guys help!
thanks

TA Performance

ttt

Sam92Teg

What axles did you get? This is usually an axle problem when it vibrates on acceleration, but at constant speeds, no vibration. This can also happen if the car is slammed putting a bad angle on the axles, causing them to wear the inner joint much quicker.

mike5809

Could also be motor mount, esp tranny one. However I would assume it is an axel. Did it just happen after you did the 5 lug conversion? Is everything installed correctly and torqed to right specs?

TA Performance

my cars not slammed, and it happen after i did a motor swap and 5 lug all at once... however i did use polyurathane motor mount inserts?? do u think thats the problem?

96teggylsse

it sounds like your inner or outer tie tod ends my civic did that and replaced them and it drove like new.... youll wanna get an allignment after you get them replaced if thats the case..... hope this helps !!! later

martyball619

yes the polyurathane motor mount inserts will cause your car to vibrate and it can also be your axles

TA Performance

already been got that alignment after i fixed it, i guess my only choice is to swap out to OEM honda axles then

Arsenal

They don't make new OEM axles anymore, they are rebuilt.

Try somewhere like Raxles.com or Gatoraxles.com both are aftermarket, I have been using raxles for awhile now, great customer service.

vgsr

i have the same problem...i swapped out my axles for some stage 1 hasports after i broke on of my stock axles....after that, its been vibrating, but the car has bad alignment that hasnt been fixed yet and i think the outer tie rod got messed up when i had to drive about a mile home w/ a busted axle im gonna put in new ingalls camber kit on the front and then get it aligned and see if it still happens

TA Performance

keep us posted!

92turboDA

Also when you get hot spots on your flywheel it will cause the face to warp and get uneven and it vibrates when accelerating, might want to check that too, I had that problem.

TA Performance

i havent driven to much since the cars been running, and i resurfaced the flywheel